.030 Magnetic on R1000

Has anyone had any luck printing on vehicle magnet? .030 to be specific. If so, what preset did you begin with? Thanks!

Hi @lasarachie, It really depends on the magnetic coating. I would recommend starting from a film generic substrate and activate as a heat-sensitive. I hope this helps.

Was this helpful?Yes0 No0

How can we improve it?

SubmitCancel

We have really good luck with .030 magnet on our R2000. The material loves moderate drying and curing temps. Your results might vary, but here's the settings we use. 8 Pass, 120 Ink Density- Optimizer: 28- Drying Temp: 65C- Curing Temp: 70C- Overcoat: Level 1- Printing Airflow: 100- Curing Airflow: 350

Was this helpful?Yes1 No0

100% of users thought this content was helpful.

How can we improve it?

SubmitCancel

#3 are you printing sheets or a full roll?

Was this helpful?Yes0 No0

How can we improve it?

SubmitCancel